Bus Configuration for I/O Modules (RAD-ISM-900-EN-BD-BUS only)
2476_en_I
PHOENIX CONTACT
5-21
5.6.3
Analog Output Module
If using the Analog Output Module, use the wiring diagram shown in Figure 5-7.
Inside the Analog Output Module are DIP switches that allow the user to determine the
status of each channel if the RF link is lost. The options are Maintain Last State and Fault
Off to a current value of approximately 2 mA. Release the top part of the housing to access
the internal DIP switches.
Figure 5-7
RAD-OUT-4A-I Analog Output Module wire diagram
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-12970-Phoenix-Contact-2900016-Radio-900-MHz-Ethernet-Radio.aspx