Startup
105752_en_03
PHOENIX CONTACT
17 / 56
3.3.2
Inserting SD cards into the Inline controllers
•
Lightly push an SD card into the SD card holder of each Inline controller until it snaps
into place.
Figure 3
-
10
Inserting the SD card
The SD cards contain the multiplexer software. They remain in the Inline controllers during
operation. Write protection for the SD cards must
not
be activated because data is saved
to the SD cards.
3.3.3
Configuring master and slave
•
Configure an Inline controller as master. Wire 24 V DC to input I1 (terminal point 1.1 to
1.2). To do this, insert a jumper as shown in
The second Inline controller will then automatically be configured as slave. The slave does
not receive any signal at input I1.
Additional information on mounting and removing the Inline controllers can be found in the
“Installing and operating the ILC 131 ETH, ILC 151 ETH, ILC 171 ETH 2TX,
ILC 191 ETH 2TX, ILC 131 ETH/XC and ILC 151 ETH/XC Inline controllers” user manual.
Additional information on mounting and removing Inline terminals can be found in the
IB IL SYS PRO UM E user manual (for INTERBUS), the IL SYS INST UM E Inline instal
-
lation manual, the Inline system manual for your bus system or the corresponding data
sheets of the Inline terminals used.
The documents can be downloaded at
.
ILC
15
1 E
TH
Ord
er-N
o. 2
700
974
HW
/FW
xx/
xxx
MA
C A
ddr
.: xx
.xx.
xx
AU
TO
MA
TIO
NW
OR
X
X
O
rd
e
r N
o
. 2
9
8
8
1
2
0
2
5
6
M
B
S
D
F
LA
S
H
2
56
M
B
>Click<
