SD FLASH 512MB MODULAR MUX
36 / 56
PHOENIX CONTACT
105752_en_03
ADD ERROR CODE Meaning
0000
hex
No error has occurred
0001
hex
Timeout during connection establishment
0002
hex
The connection is interrupted.
0003
hex
Manual acknowledgment required
0004hex
SafetyBridge communication breakdown
0101
hex
The bus length of the master is greater than the bus length of the slave.
0102
hex
The bus length of the slave is greater than the bus length of the master.
02xx
hex
The bus configuration of the master does not match the bus configuration of the
slave (xx = number of faulty bus segment).
C350
hex
Slave error, error message of “FB_Connection” block
0000
hex
The slave reports its status every time a write command is sent by the master. If a
malfunction or an error has occurred, this is reported to the master via the status
and indicated in this error code.
In this case, more precise error diagnostics can only be performed for the slave.
C4xx
hex
Device error of an INTERBUS device in the connected bus system (xx = number of faulty bus segment).
The additional error codes “ADD ERROR CODE” provide more information on this error message.
ADD ERROR CODE Meaning
8001
hex
Measuring range exceeded (overrange)
8002
hex
Open circuit
8004
hex
No valid measured value available
8010
hex
Configuration invalid
8020
hex
DAC voltage has fallen below the permissible value.
8040
hex
Module faulty (replacement required)
8080
hex
Below measuring range (underrange)
Table 4
-
1
Diagnostic error codes
Error code
Meaning
Please note the following when determining the faulty bus segment:
Associated AO1 modules that are operated together on an AI2 module
are viewed as one bus device.
Please note the following when determining the faulty bus segment: Associated AO1 modules
that are operated together on an AI2 module are viewed as one bus device.