SD FLASH 512MB MODULAR MUX
10 / 56
PHOENIX CONTACT
105752_en_03
The SD cards contain the multiplexer software. They remain in the Inline controllers during
operation. Write protection for the SD cards must
not
be activated because data is saved
to the SD cards.
3.1.3
Connecting the Inline controllers to each other
The two Inline controllers are connected to each other via their respective Ethernet connec
-
tions. There are two possible connection options:
– Direct connection between the Inline controllers
– Wireless connection between the Inline controllers
Direct connection between the Inline controllers
•
Connect the two Inline controllers to each other using an Ethernet cable.
Figure 3
-
2
Direct connection between the Inline controllers using an Ethernet cable
Wireless connection between the Inline controllers
For the wireless connection between the Inline controllers, you require an adapter for each
Inline controller (e.g., FL EPA 2 adapter, Order No. 1005955).
•
Connect each Inline controller to an adapter for wireless communication using an
Ethernet cable.
Further adapters can be found in
Section “Ordering data” on page 40
Observe the notes and descriptions provided in the respective user manuals and packing
slips for the adapters used.
AUTOMATIONWORX
ILC 131 ETH
Order-No.: 2700973
HW/FW: xx/xxx
MAC Addr.: xx.xx.xx.xx
RESET
PRG
LNK
ACT
X2
X1
UL
US
UM
FF
I1
I3
I2
I4
Q4
E
I5
I7
I6
I8
Q3
Q2
Q1
RDY FAIL
BSA PF
FR
RUN / PROG
MRESET
STOP
AUTOMATIONWORX
ILC 131 ETH
Order-No.: 2700973
HW/FW: xx/xxx
MAC Addr.: xx.xx.xx.xx
RESET
PRG
LNK
ACT
X2
X1
UL
US
UM
FF
I1
I3
I2
I4
Q4
E
I5
I7
I6
I8
Q3
Q2
Q1
RDY FAIL
BSA PF
FR
RUN / PROG
MRESET
STOP
Ethernet
105752A001
