SD FLASH 512MB MODULAR MUX
16 / 56
PHOENIX CONTACT
105752_en_03
3.2
Using SafetyBridge technology for the multiplexer
system in the wireless network
When using I/O modules with SafetyBridge Technology in the multiplexer system, you need
to configure each SafetyBridge module as described in the user manual for the respective
module.
The following wireless modules can be used as adapters for wireless connection of the In
-
line controllers:
– FL BT EPA 2 (Order No. 1005869)
– FL EPA 2 (Order No. 1005955)
– FL EPA 2 RSMA (Order No. 1005957)
You can set the operating mode for the adapter via the “Mode” button on the adapter used.
Additional information on the “Mode” button and individual operating modes can be found
in the user manual of the adapter used.
3.3
Integrating the multiplexer system into an Ethernet
network
Sections
to
describe how to integrate the two multiplexer system stations into
an Ethernet network.
•
Follow the instructions in Sections
to
.
•
Adhere to the sequence of the sections.
3.3.1
Mounting the Inline controllers
•
Mount the ILC 131 ETH Inline controllers at a suitable position on a 35 mm standard
DIN rail.
In order to operate the system in compliance with the SafetyBridge specification, use the
adapters for wireless communication in a mode with PROFINET/PROFIsafe optimization.
NOTE: Not a safe application
In order to ensure correct use, subsequent safety logic (an evaluation unit) is required.
Additional information on how to use the multiplexer system in conjunction with Safety
-
Bridge Technology can be found in the
AH EN SD FLASH 512MB MODULAR MUX SAFETYBRIDGE application note.
The application note can be downloaded at
