Startup
105752_en_03
PHOENIX CONTACT
23 / 56
3.3.7
Assigning the IP address for the Inline controller
The IP address for the Inline controller in the network is assigned via the web interface of
the multiplexer system.
•
Open your web browser.
•
Enter one of the following addresses, depending on for which Inline controller you want
to assign the IP address in the network:
– http://192.168.0.2/entry.html (default IP address for the master)
– http://192.168.0.3/entry.html (default IP address for the slave)
The web interface of the multiplexer system opens.
Figure 3
-
16
“General”
start page of the web interface (master window)
•
Click the “ILC 131 ETH” button.
•
In the window that opens, click the “Set IP Address” button.
The “Set IP Address of ILC 131 ETH” page for assigning an IP address to the Inline control
-
ler (
) opens.
