SD FLASH 512MB MODULAR MUX
32 / 56
PHOENIX CONTACT
105752_en_03
4.2.2
“Set IP Address of ILC 131 ETH” page
On the “Set IP Address of ILC 131 ETH” page, you can modify the IP address of the Inline
controller.
Figure 4
-
4
Web interface: “Set IP Address of ILC 131 ETH” page
•
In the “Local PLC” area, set the IP address, the subnet mask and the gateway address
for the Inline controller for which you have opened the multiplexer web interface.
•
In the “Remote PLC” area, enter the IP address of the other Inline controller.
•
To transfer the modified IP address to the Inline controller, click the “Send” button.
The “Home” button takes you back to the “General” start page (see
).
The “Back” button takes you back to the “State of ILC 131 ETH” page (see
).
Please note: By default, the IP address of the Inline controller is automatically reset to its
default IP address after a voltage reset. In order to prevent this from happening, you must
configure the behavior after a voltage reset as described in