SD FLASH 512MB MODULAR MUX
6 / 56
PHOENIX CONTACT
105752_en_03
1.3
Field of application of the product
1.3.1
Intended use
The SD FLASH 512MB MODULAR MUX SD card is intended for creation of a multiplexer
system in combination with the ILC 131 ETH controller.
Two of these SD cards, with two ILC 131 ETHs and the individually required input and out
-
put terminals, form a multiplexer system that requires no programming.
1.3.2
Foreseeable misuse
The SD FLASH 512MB MODULAR MUX multiplexer system is not intended for implemen
-
tation of safety-related startup inhibits.
•
Always implement the safety-related startup inhibits outside of the multiplexer system
using safety-related parts of the controller.
•
When doing so, observe the relevant basic and proven safety principles.
1.3.3
Modifications to the products
Modifications to the hardware and firmware of the ILC 131 ETH Inline controller are not per
-
mitted.
Modifications to the SD FLASH 512MB MODULAR MUX SD card are not permitted.
Incorrect operation or modifications to the products can endanger your safety or damage
the products. Do not repair the products yourself. If the products are defective, please con
-
tact Phoenix Contact.
1.4
Safety notes
Observe the country-specific installation, safety, and accident prevention regulations.
During startup and maintenance work, proceed in accordance with the five safety rules of
DIN EN 50110-1. In general, the rules should be observed in the order indicated below:
– Disconnect safely
– Ensure power cannot be switched on again
– Verify safe isolation from the supply
– Ground and short circuit
– Cover or safeguard adjacent live parts
Once the work is complete, perform the above steps again in reverse order.
