TRIO-PS-2G/3AC/24DC/40
105907_en_00
PHOENIX CONTACT
11 / 25
5
Safety regulations and installation
notes
Before startup please ensure:
–
Only skilled persons may install, start up,
and operate the device.
–
Observe the national safety and accident
prevention regulations.
NOTE: Danger if used improperly
–
The device is a built-in device.
–
The IP20 degree of protection
(IEC
60529/EN
60529) of the device is
intended for use in a clean and dry
environment. Do not subject the device to
any load that exceeds the described
limits.
–
Do not subject the device to mechanical
and/or thermal loads that exceed the
specified limits.
–
It is not permissible to open or modify the
device. Do not repair the device yourself
but replace it with an equivalent device.
Repairs may only be carried out by the
manufacturer. The manufacturer is not
liable for damage resulting from violation.
CAUTION:
Before startup please ensure:
–
Connection must be performed by
specialist personnel and protection
against electric shock ensured.
–
It must be possible to switch off the
device outside the power supply
according to the regulations in EN 60950-
1 (e.g., by line protection on the primary
side).
–
All feed lines are sufficiently protected
and dimensioned!
–
All output lines are dimensioned
according to the maximum output current
of the device or separately protected!
–
Sufficient convection is guaranteed!
EXPLOSION HAZARD!
Only remove equipment when it is
disconnected and not in the potentially
explosive area.
DANGER
Never carry out work on live parts!
The housing can become very hot, depending
on the ambient temperature and load!
