UM EN OPC 7015/OPC 7022
8155_en_00 PHOENIX
CONTACT
3
I
NSTALLATION
3.1
I
NSTALLATION OPTION
This device is intended for integration into switch panels or switching cabinets. In order to
allow for a safe installation and operation (connector access), these switch panels or
control desks must be accessible from the back. The device can be integrated into
switching cabinets with a wall thickness of 2 to 13 mm. We recommend a minimum of 3
mm for correct installation with an IP65 front protection class.
Warning:
To avoid overheating in operation: The device must not be exposed to direct radiation by
sunlight or any other light or heat source.
If the device is integrated in a panel, casing or similar enclosures, you must ensure that
no heat accumulation builds up. The maximum permissible environmental temperature
must never be exceeded.
Devices including a data drive must only perpendicularly be integrated. Any deviation
must be agreed with Phoenix Contact.
The IP65 protection class is only achieved after correct installation.
Note:
When selecting the enclosure for integration, the power dissipation total of the system
including that of all integrated PCBs must be taken into account. The enclosure must be
calculated in such a way that the maximum environmental temperature is not exceeded in
any case.
Pos: 16 /Datentechnik/Montage/Montageskizzen/Außenabmessungen des Geräts/Montageskizze des Geräts OPC 7013 / 7015 / 7022 @ 2\mod_1257325856744_6.doc @ 6786 @
