www.hartmann-electronic.com
Rev. 1.2
5
1. Safety
Intended Application
PXI Express PXCe4006 series chassis are not end-products with independent functionality according the
EMC regulations, an operational system is achieved only by combining the chassis with appropriate plug-
in PCI/PXIe instruments. As a consequence formal certification requirements as the for instance the CE
marking do not apply to it.
The completion and final testing of the units has to be carried out, or at least supervised, by a qualified
technician. The following instructions are directed exclusively to this qualified personal, i.e. engineers,
trained and qualified electricians etc.
Make sure that the finished system complies with the safety regulations currently applicable in the
country in which it will be used.
Safety Symbols
Hazardous voltage!
Familiarise yourself with the danger of electrical voltages and the safety
precautions before starting to work with parts that carry dangerous voltages
Caution!
This symbol indicates a condition where damage of the equipment or injury of
the service personnel could occur. To reduce the risk of damage or injury,
follow all steps or procedures as instructed.
Danger of electrostatic discharge!
Static electricity can damage sensitive components in a system. To avoid
damage, wear ESD wrist straps or at regular intervals touch blank enclosure
parts.
General Safety Precautions
Warning!
Voltages over 60 VDC can be present in this equipment. This equipment is
intended to be accessed, to be installed and maintained by qualified and trained
service personnel only.
This equipment is designed in accordance with protection class 1!
lt must therefore be operated only with protective GND/earth connection!
