Rev. 1.3
26
https://www.hartmann-electronic.com/
Figure 5-2 Air Filter Replacement (sample: 2U version)
•
Removing the Fan Tray as described in 5.1 (Replacing the Fan Tray).
•
Slide the air filter towards the connector and remove the filter from the fan tray.
•
Place the new filter to the fan tray and fix filter.
•
Reinstall the fan tray/air filter back into the shelf.
•
The fans must be able to rotate
5.3
Replacing the Power Supply
The AC Power Supply can be accessed from the front on the right hand side of the subrack.
Removing the Power Supply
The steps required for removing the AC Power Supply as follows:
•
Loosen the two mounting screws (left and right) on the front of the AC Power Supply.
•
Open the handle, pull the Power Supply out toward the front of the subrack until the interface
connector disengages.
Installing the Power Supply
The steps required for installing the Power Supply as follows:
•
Insert the replacement Power Supply into the shelf guide rails and ensure that the interface
connectors align.
•
Close the handle
•
Tighten the two mounting screws (left and right) on the front of the AC Power Supply.
Figure 5-3 Replacing the Power Supply (sample: 2U version)
