Rev. 1.3
2
https://www.hartmann-electronic.com/
2
Safety
2.1
Intended Application
The VME64x System Platform Basic subracks is intended as a platform for a microcomputer
system based on the VME64x Standard ANSI/VITA 1.1- 1997
VME64x System Platform Basic subracks are not end-products, so there is no valid approval
for this unit. In Order to enable stand-alone functionality, additional elements are required.
An operational system is achieved only by way of appropiate VME64 boards.
The completion and final testing of the units have been carried out, or at least supervised, by
qualified technicians. These instructions are directed exclusively to these qualified
technicians i.e.engineers, trained and qualified electricians etc.
Make sure that the finished system complies with the safety regulations currently applicable
in the country it is going to be used.
2.2
Safety Symbols
Hazardous voltage!
Familiarise yourself with the danger of electrical voltages and the safety
precautions before starting to work with parts that carry dangerous voltages
Caution!
This symbol indicates a condition where damage of the equipment or injury of the
service personnel could occur. To reduce the risk of damage or injury, follow all steps
or procedures as instructed.
Danger of electrostatic discharge!
Static electricity can damage sensitive components in a system. To avoid damage, wear
ESD wrist straps or at regular intervals touch blank enclosure parts.
2.3
General Safety Precautions
Warning!
Voltages over 60 VDC can be present in this equipment. This equipment is intended to be
accessed, to be installed and maintained by qualified and trained service personnel only.
This equipment is designed in accordance with protection class 1!
lt must therefore be operated only with protective GND/earth connection!
