45
44
46
Control horn
Install the rudder servo to the fuselage as shown.
INSTALLING THE RUDDER SERVO
Remove the covering from the exit slot for rudder.
. The control horn should be mounted on the
right side of the rudder at the leading edge, in
line with the rudder pushrod.
47
12
CAP 232
Instruction Manual
MOUNTING THE COWL
1. Remove the muffler and needle valve assembly
from the engine. Slide the fiberglass cowl over
the engine.
2. Measure and mark the locations to be cut out
for engine head clearance, needle valve,
muffler. Remove the cowl and make these cut
outs using a rotary tool with a cutting disc and a
rotary sanding drum attachment.
3. Slide the cowl back into place. Align the front of
the cowl with the crankshaft of the engine. The
front of the cowl should be positioned so the
crankshaft is in the middle of the precut
opening. Hold the cowl firmly in place using
several pieces of masking tape.
4. While holding the cowl firmly in position, drill
four 1,6mm pilot holes through both the cowl
and the side edges of the firewall.
5.
Using a 3mm drill bit, enlarge the four holes in
the cowling.
Enlarging the holes through the cowl will prevent
the fiberglass from splitting when the mounting
screws are installed.
6. Slide the cowl back over the engine and secure
it in place using four 3mm x 12mm wood screws.
7. Install the muffler. Connect the fuel and
pressure lines to the carburator, muffler and
fuel filler valve. Tighten the screws completely.
43
165mm
22mm
22mm
INSTALLING THE RUDDER LINKAGES
. Repeat these step as installing the aileron
linkages (Page 4 and page 5).
!
