onlinecomponents.com
P1 ENGRAVING UNIT
12
PHOENIX CONTACT
103072_00_en
Cleaning the Motor Filter
Figure 22
Motor filter
•
If the cover has been opened as described above, the
motor filter can be removed.
•
Carefully remove the motor filter from the chamber for
the vacuum cleaner bag.
Simply clean this filter as required.
Handling the Engraving Spindle
Cleaning the Engraving Spindle
Figure 23
Cleaning the collet chuck of the engraving
spindle
•
Remove the graver and unscrew the collet chuck
completely using the rotary knob (see page 10).
•
Wipe the front part of the collet chuck seat with a clean
cotton bud.
•
Switching from Engraving to Plotting
To switch from engraving back to plotting, perform the
above in reverse order.
•
Switch off the plotter and control unit and disconnect
the mains plug on both devices.
•
Disconnect the suction tube and connecting cable from
the engraving head.
•
Disconnect the control unit from the plotter and vacuum
cleaner.
•
Remove the support pipe with holder.
•
Remove the cover from the engraving head.
•
Remove the terminal screw and remove the engraving
spindle.
•
Release counter bearing.
•
Release the interlocking device on the engraving head
and pull the engraving head out of the plotter arm.
•
Assemble the pen lowering unit and insert the locking
pin. Fit the plastic cover.
Then change the default values for engraving mode:
•
In the CMS-MARK-WIN software, select the
"Settings... Default values..." menu.
•
On the "Plotter output" tab, adjust the following items:
– Change the speed for all items to 2 cm/s.
– Activate the "Startup function" option, if required.
– Confirm the parameters with "OK".
The engraving spindle is a sensitive unit and
must be handled with extreme care.
Only use the engraving spindle in dust-free
rooms. An excessively high level of dust can
result in the sensitive bearing becoming
clogged with dust and quickly wearing out.
Do not use a lubricant for engraving.
Never clean the engraving spindle with
compressed air, as this will remove lubricant
from the ball bearings.
Never use water to clean the engraving
spindle.
