CONNECTING THE BLAST GUN
1. Use 1¼” and 1½” wrenches to connect the gun to the end of the blast hose with the
shorter length trigger lines. Do not over-tighten. (pic 1)
2. Connect the respective trigger lines (different sizes) to the gun, pushing firmly into the
quick-connect fittings. (pic 2)
3. Install the nozzle by a) twisting threaded retainer to completely ‘open’ position;
b) place nozzle into end of blast gun; c) tighten retainer to secure the nozzle. Improper
seating of the nozzle in the gun may result in air leakage. (pics 3, 4, 5)
4. Using the 1½” wrench, connect the remaining end of the blast hose to the front of the
PHX-150. (pic 6)
5. Connect the two trigger lines to the unit, pushing firmly until seated. Failure to attach
trigger lines will result in the non-functioning of the unit. (pic 7)
6. If necessary, ground the item you are blasting.
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
P
P
H
H
X
X
-
-
1
1
5
5
0
0
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Page 11
Pic 1
Pic 2
Pic 3
Pic 4
Pic 5
Pic 6
Pic 7
