SETTING THE PANEL CONTROLS
Applying Air to the Unit
1. Slowly open the main air supply valve (source). (pic1)
2. With the gun pointed in a safe direction, slowly open the E-Stop valve on the
PHX-150. (pic 2)
Setting the Panel Controls
1. Pull the ‘Ice Rate’ knob outwards to unlock it. (pic 1)
2. Turn the control clockwise until the gauge reaches the desired pressure. If unsure, start
at about 25 psi, then adjust the rate up or down as necessary for your particular blasting
application. (pic 2
)
Note: Trigger on gun must be pulled in order for gauge to read!
3. Push the knob in to lock the ice rate. (pic 3)
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
P
P
H
H
X
X
-
-
1
1
5
5
0
0
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Page 13
Pic 2
Pic 1
Pic 2
Pic 1
Pic 3
