P
P
H
H
O
O
E
E
N
N
I
I
X
X
U
U
N
N
L
L
I
I
M
M
I
I
T
T
E
E
D
D
L
L
L
L
C
C
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
P
P
H
H
X
X
-
-
2
2
0
0
0
0
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
U
U
S
S
E
E
R
R
S
S
G
G
U
U
I
I
D
D
E
E
P
P
G
G
.
.14
APPLYING AIR TO THE UNIT
1.
Slowly open the main air supply valve (source). (pic1)
2.
With the gun secured and pointed in a safe direction, slowly open the system supply valve on the
PHX-200. To open pull outward on locking collar and turn handle to the left. (pic 2)
SETTING THE PANEL REGULATORS
(NOTE: The Panel Regulators may be adjusted at any time.)
ICE RATE CONTROLS
1.
If locked, pull the ICE RATE knob outwards to unlock it.
2.
Turn the knob clockwise to desired pressure. If unsure, start at about 25 PSI, then adjust the rate
up as necessary for your particular blasting application.
Note: It is normal for the pressure to drop 3-7 PSI (proportional to the set pressure)when
trigger is pulled, so adjust accordingly Experience will dictate proper settings.
3.
Push the knob in to lock the ice rate.
BLAST AIR CONTROLS
1.
Loosen jam nut on the tee handle to unlock it.(1/2” wrench)
2.
Turn tee handle clockwise until desired pressure is reached. The PHX-200 has a blast pressure
range from 45-250 PSI. If you are unsure or are concerned about damage to the item being
blasted, start at a lower blast pressure and increase it gradually until the optimum performance
level is achieved.
3.
Tighten jam nut to lock the blast air pressure.
Note: The PHX-200 is factory set to purge air and ice 3 seconds at 45 PSI after trigger is released
to clear the airlock and hose and prevent any clogging on the next trigger pull.
Pic 2
Pic 1
