You can see one of the round head screws that holds the shroud, lower and upper section all in
place. There are 2 more to the left and right of this along the side. These screws are M3 and please
be careful when tightening these to prevent stripping. Tighten them down but don
’
t go all Hercules
on them. It
’
s unnecessary.
Here you can see the triforce screw. This is a 2 piece screw. A peg and a head. You will insert the peg
through the shroud from the inside, and hold this peg with your finger. Then from the other side you
can screw down the top of the screw. If you are simply displaying you might have to add a small
spacer to keep this screw head from wiggling. For installation under here is a location for your
