SELO-B (Version 1.0)
Electronic lock
USER INSTRUCTIONS
Clearing the lock without opening
delay (factory setting)
1) Press On/Enter key. When the lock is ready for operation, the
welcoming phrase on the display will soon be replaced by a
message prompting the operator to enter a secret code. The
black, rectangular cursor sits blinking at the first digit of the
code entry field.
2) Key-in the 7- or 8-digit number code
(factory setting:
administrator code 1 2 3 4 5 6 7).
Following each successful
entry a star appears in the space just completed, and the
blinking cursor shifts one place to the next figure to be entered.
After entering the last digit, the code is validated by the lock.
3) If the lock is able to match the entry with a previously
programmed code, it will prompt the operator for five seconds
to turn the round input unit and to start unblocking the lock.
Unblocking the lock - relocking and
securing the lock
1) To unblock the lock during the five second readiness for opening,
turn the round input unit clockwise through a half turn from its
end position. Please note that the input unit can be turned a
quarter turn at any time, but that this distance is not enough to
unblock the lock.
or:
Clearing the lock with a pre-set opening
delay (between 1 and 99 minutes)
1) Press On/Enter key. When the lock is ready for operation, the
welcoming phrase on the display will soon be replaced by a
message prompting the operator to enter a secret code. The
black, rectangular cursor sits blinking at the first digit of the
code entry field.
2) Key-in the 7- or 8-digit number code
(factory setting:
administrator code 1 2 3 4 5 6 7).
Following each successful
entry a star appears in the space just completed, and the
blinking cursor shifts one place to the next figure to be entered.
After entering the last digit, the code is validated by the lock.
3) If the lock is able to match the entry with a previously
programmed code, it starts the preset opening delay and
displays the remaining waiting time. If the lock cannot match
the entered code to a valid code, it will send out a fault
message.
4) Wait for the opening delay to come to an end. Until it does, the
lock cannot be opened. At the end of the opening delay, the
operator is prompted to enter a valid code.
5) Key-in the valid code once more.
6) As a sign of its readiness for unblocking, the lock will prompt
the operator for five seconds to turn the round input unit and
start unblocking the lock.
2) If the input unit is turned back to its starting position in
anti-clockwise direction after the five second ready for opening
period, the lock will return to the blocked position and can only
be unblocked after renewed clearing and re-entry of a valid code.
B) OPERATION