CONNECTING TO A SIP/IP LINE
For any session using an IP telephone provider (IP/SIP).
‣
Using the Ethernet cable provided, plug one end of the cable into the Spider’s Ethernet
connector (located on the connector panel below the unit).
‣
Plug the other end of the cable directly into your Ethernet wall socket.
‣
Make sure that the Spider is either plugged into a power source
OR
that your home or
office is equipped with Power over Ethernet (PoE).
‣
It is important that your Spider is registered with an IP service provider (See the
following Control Portal section).
THE CONTROL PORTAL (SETTING UP THE SIP)
The online control portal will allow you to control and adjust all of your IP phone settings. To
access:
‣
Enter the phone menu by pressing .
‣
Using the and buttons, scroll to “Information” and click to select (or just
press the number 7 after entering the menu).
‣
The first option under the “Information” submenu is your unit’s IP address.
‣
Open a web browser and type in your Spider’s IP address in the address bar and press
enter.
‣
A Username / Password prompt will appear. Enter
admin
as your username and
1234
as your password, then click on “Log In”.
NOTE:
To access the portal, your computer must be located on the same LAN as the Spider.
PORTAL OVERVIEW
QUICK SETUP
Adjust the LAN, SIP Proxy, and Registrar options.
PERSONAL SETTINGS
Directory
Add contacts to phone.
Page 5
