ComPilot
II
Troubleshooting
Pairing a ComPilot
II
with
the TVLink
II
1. Verify the ComPilot
II
is “on” with green flashing light
above Power.
2. Turn the TVLink
II
on.
3. Delete pairings on the TVLink
II
by doing
the following:
a. Press and hold the “P” button on the back of
the device until it starts rapidly blinking blue.
b. Continue to hold for approximately 10 seconds
until the light turns green.
c. The light will then start to rapidly blink blue.
It is now in pairing mode.
4. Press the “< >” button on the left and the “+” button
on the front of ComPilot
II
simultaneously and hold
them down for 2 seconds until the Audio indicator
starts to rapidly blink blue. Release as soon as you see
the rapidly blinking blue light.
5. Place the ComPilot
II
and TVLink
II
next to each other.
6. Within 2 minutes, the ComPilot
II
and TVLink
II
lights
will be solid blue.
You can now use the ComPilot
II
with the TVLink
II
.
Pairing the ComPilot
II
with
the RemoteMic
1. Verify the ComPilot
II
is “on” with green flashing light
above Power.
2. Delete the pairings on the RemoteMic by doing
the following:
a. Verify RemoteMic is “off” and not showing lights.
b. Press and hold down the volume up (+) button
at the same time as turning the RemoteMic “on.”
The green light will appear, followed by a rapidly
blinking blue light.
c. Continue to hold the volume up (+) button for
approximately 10 seconds until the light goes
back to green and then release.
d. The light will now be rapidly flashing blue. It is
now in pairing mode.
3. Press the < > button on the side and the (+) button
on the front of ComPilot
II
simultaneously and hold
them down for 2 seconds until the Audio indicator
starts to rapidly blink blue. Release as soon as you see
the rapidly blinking blue light.
4. Place the ComPilot
II
and RemoteMic next to
each other.
5. Within 2 minutes, the ComPilot
II
and RemoteMic
lights will be solid blue.
You can now use the ComPilot
II
with the RemoteMic.
