PhoneWatch Smart Alarm, User Manual

8 

HOW TO USE THE ALARM SYSTEM

How to use the alarm system

The alarm system is easy and convenient to operate using the 
keypad, remote control or keytag.

Activate using the keypad

Full Arm mode (activates the entire alarm system)

Close all of the exterior doors and windows before activating the alarm.

Push the button. A beep will sound and the button will light up.

Enter your 4-6 digit code to arm the alarm.

In the case of a system error, a warning signal will be emitted. You should fix the

   system error and then try to activate the alarm again. Refer to page 7 to identify 

   the error.

Part Arm mode (activates part of the alarm system*)

Close all of the exterior doors and windows before activating the alarm.

Push the button. A beep will sound and the button will light up.

Enter your 4-6 digit code to arm part of the alarm.

When part arm is active, the part arm button will blink once every 10 seconds to 

indicate that the system is active.

In the case of a system error, a warning signal will be emitted. You should fix the

system error and then try to activate the alarm again. Refer to page 7 to identify 

the error.

Check status

To check the status of the alarm system,  press any numeric button and the button

    confirming the current activation status will light up for 2 seconds.

* 

Part Arm mode

is programmed according to your needs. The PhoneWatch Security Advisor will

program the alarm according to your preferences.

Activate using the remote control

Keep in mind that the remote control activates and deactivates the system without a PIN code or 

keytag. You should therefore keep it in a safe place so that only authorized people have access

to it.

Full Arm mode (activates the entire alarm system)

Close all of the exterior doors and windows before activating the system.

Press and hold the button for 2 seconds on the remote control to quick arm the alarm. 

All the button lights will blink to confirm the action and the selected button light will light up for

2 seconds.

Part Arm mode (activates part of the alarm system*)

Close all of the exterior doors and windows before activating the system.

Press and hold the button for 2 seconds on the remote control to quick arm part of

the alarm.

All the button lights will blink to confirm the action and the selected button light will light up for 2 

seconds.

Check status

To check the status of the alarm, press and hold the button for 2 seconds and the

    button confirming the current activation status will light up for 2 seconds.

* 

The PhoneWatch Security Advisor will program the alarm according to your preferences.

SOS-function

Activating Full Arm mode 

Deactivation button

Activating Part Arm mode

Status button

HOW TO USE THE ALARM SYSTEM 

9