20
19
OPUS
Liquid Crystal
OPUS
Liquid Crystal
8. Open the hood and loosen the adjustment bolt
until the platform is free to move, using the T25
L-Shape Torx Key. Ensure the platform is straight
and level, then close the printer hood.
4. Select ‘Vat’.
5. Loosen two bolts on the vat bracket at the rear of
the printer using a T25 L-Shape Torx Key.
9. Tighten the two bolts on the vat bracket fully using
the T25 L-Shape Torx Key.
10.Select ‘Finish’.
6. Close the printer hood and select ‘Start’.
7. Open printer hood, insert vat and apply downward
8. Select ‘Next’
12. Close the printer hood.
13. Select ‘Finish’, the platform will return to its
homing location.
Resin Vat Re-Calibration
To watch a video on Print Platform Re-Calibration
click here.
1. Ensure the resin vat is completely clean and free
from debris and remove vat from the printer.
2. On the ‘Main’ screen, select ‘Maintain’.
11. Tighten the adjustment bolt fully using the T25
L-Shape Torx Key.
9. Select ‘Next’.
10. Align the platform so that it sits straight and level
on the screen.
10.4 PRINTER HOOD ADJUSTMENT
Over time, repeated use of the print hood may cause
it to loosen and remove the self-supporting ability of
the hood in the open position.
To rectify this issue, the hood bearing mount will
need to be adjusted.
Tighten the screw in the centre of the bracket from
the outside of the printer hood on each side using
the T25 L-Shape Torx Key.
Tighten the nut from inside of the printer using a 10
mm spanner.
