7 Software
SetFeature(’MROI_Enable’, false);
SetFeature(’MROI_Index’, 0);
SetFeature(’MROI_Y’, 50);
SetFeature(’MROI_H’, 100);
SetFeature(’MROI_Index’, 1);
SetFeature(’MROI_Y’, 600);
SetFeature(’MROI_H’, 300);
SetFeature(’MROI_Index’, 2);
SetFeature(’MROI_H’, 0);
SetFeature(’MROI_Enable’, true);
int heightTot;
GetFeature(’MROI_Htot’, &heightTot);
SetFeature(’Height’, heightTot);
7.8
Permanent Parameter Storage / Factory Reset
The property
UserSetSave
(in category
UserSetControl
) stores the current camera settings in the
non-volatile flash memory. At power-up these values are loaded.
The property
UserSetSave
(in category
UserSetControl
) overwrites the current camera settings
with the settings that are stored in the flash memory.
The command
CameraHeadFactoryReset
(in category
PhotonfocusMain
) restores the settings of the
camera head
The property
CameraHeadStoreDefaults
(in category
PhotonfocusMain
) stores only
the settings of the camera head in the flash memory. It is recommended to use
UserSetSave
instead, as all properties are stored.
The calibration values of the FPN calibration are not stored with
UserSetSave
(or
CameraHeadStoreDefaults
). Use the command
Correction_SaveToFlash
for this (see
Correction_SaveToFlash
).
7.9
Persistent IP address
It is possible to set a persistent IP address:
1.
Set
GevPersistentIPAddress
(in category
TransportLayerControl
) to the desired IP address.
2.
Set
GevPersistentSubnetMask
(in category
TransportLayerControl
) to the sub net mask.
3.
Set
GevCurrentIPConfigurationPersistent
(in category
TransportLayerControl
) to True.
4.
Set
GevCurrentIPConfigurationDHCP
(in category
TransportLayerControl
) to False.
5.
The selected persistent IP address will be applied after a reboot of the camera.
.
108
Summary of Contents for D/L-2048
