Photonic Universe Ltd
- Bringing you the benefits of solar power -
Registered office:
Tel: +44 (0) 203 150 11 11
13 David Mews
Fax: +44 (0) 203 150 12 12
Porter Street
Email:
info@photonicuniverse.com
London W1U 6EQ UK
Web shop:
www.photonicuniverse.com
20W 12V solar charging kit
Instruction manual
Dear Customer,
Thank you very much for choosing Photonic Universe products! This manual explains the installation of
your solar kit and answers some frequently asked questions. Please read this manual carefully before
setting up the system.
Remember, all work should be carried out by an appropriately qualified person. Precautions and safety
measures should be taken in all cases.
Contents of the package
№
Item
Quantity
1
20W 12V polycrystalline solar panel with 3m cable
1
2
5A solar charge controller
1
3
2m battery cable with crocodile clips (used between the controller and your battery)
1
4
5A fuse in a holder (installed on the battery cable)
1
5
Instruction manual for the solar controller
1
6
Instruction manual for the kit
1
Installation of the solar kit
1. Before you install the solar kit, please make sure your 12V battery is not fully discharged. The
battery should produce at least 6V - this voltage is required to start the solar charge controller. If
your battery is fully discharged, please charge it by other means first for a short period of time.
2. Connect your 12V battery to the solar charge controller using the 3m cable with crocodile clips:
−
On the solar controller end, fix bare ends of the cable using screw terminals
−
On the battery end, use crocodile clips attached to the cable
Battery “+” should be connected to “+” battery terminal of the controller, battery “-“ should be
connected to “-“ battery terminal of the controller.
Please note: crocodile clips are provided for temporary use only. For permanent connection we
recommend using special battery terminals or your existing battery connectors.
3. Connect solar panel to the solar charge controller: “+” lead should be connected to “+” solar
terminal of the controller, “-“ lead should be connected to “-“ solar terminal of the controller. Your
solar kit should start charging the battery. For maximum output make sure the solar panel is
located outdoors and exposed to as much sunlight as possible without any shading. Even a small
shaded area can reduce the output significantly (e.g. leaves, trees etc.).
4. If needed, you can connect any 12V load or appliances to load terminals of the solar controller
(“+” to “+”, “-“ to “-“), for example 12V light bulbs. Make sure the total current drawn by the
load does not exceed 5A.
Your 12V load or appliances can also be connected directly to your battery, however in this case
the discharge protection function of the solar controller won’t work (the controller won’t be able to
cut off the load automatically when it’s over discharging the battery).
5. The solar panel and its connection box at the back are waterproof and can be used outdoors in
any weather conditions. Solar charge controller is not waterproof and should always be used
indoors.
6. Please refer to the solar controller manual for information on how to operate the controller.
