Control Mode :
Knob + Button
Rated Power :
48W
Input :
24 VCD
Product Dimension :
L27.7 x W20.7 x H46.7 cm
Specifications
Washing Bucket Volume :
8 L
Maximum Model Size :
L21.8 x W12.3 x H23.5 cm
Weight :
3.5 kg
Timer :
0 - 30 minutes
Before You Start
01
▎
Place the machine on a clean and level surface.
▎
Put the washing basket into the bucket.
▎
Please make sure to wear protective goggles, gloves, masks, and long-sleeved clothing when handling the machine.
▎
Pour in an appropriate amount of alcohol
(95%)
or other cleaning fluid
(Phrozen Wash)
.
▎
Cover the bucket when the machine is in use to avoid splashing and objects falling.
▎
Keep the bucket covered to avoid alcohol evaporation when the machine is not in use.
Instructions
02
After printing is completed hang the building plate with prints on the cleaning basket (if the building
plate is smaller than 7”, use the basket holder). For building plate over 10” put the prints straight into
the cleaning basket.
Turn the knob to adjust the time and press to set. It is recommended that each cleaning time should not
exceed 30 seconds as overcleaning might damage the prints.
After the timer stops, lift the basket vertically and take out the prints.
Leave prints to dry or use an air gun to accelerate the drying process.
For hollow and more complicated models, please make sure the prints are clean. If any residual resin was
found, repeat steps 2-5.
After the cleaning process is completed, put prints into the curing machine to cure.
1
2
3
4
5
6
Warning
▎
▎
▎
▎
▎
Please disconnect the power before cleaning or replacing alcohol (cleaning fluid).
DO NOT
pour resins or other liquid except alcohol (cleaning fluid) into the cleaning bucket.
Avoid direct contact with skin to prevent allergies.
In case of contact with resin and alcohol (cleaning fluid), please rinse immediately with plenty of water.
DO NOT
remove prints from the bucket when the machine is running.
Washing Bucket
Washing Basket
Holder
Washing Basket
Timer Display
Display the remaining
cleaning time.
Setting Knob
Set Time
｜
Turn the knob to
adjust the time and press it to
set.
Pause
｜
When the machine is
running, press the knob to
pause.
Reset Timer
｜
Long press the
knob to reset the timer.
Note :
Regularly replace 95% alcohol (cleaning fluid) for optimum results.
Scan for other
languages
YouTube
Help Center
Phrozen Wash & Cure Kit User Guide
Washing Station Post Printing Cleaner
A
B
A
B
