Document: 8008-02-01.0
Hardware Topology and Installation Overview
1. Remove the PoLRE switch and all accompanying accessories.
2. Remove all legacy analog/digital phones from the RJ11 wall jacks.
Note: It is extremely important that no legacy phones be connected when you power on the PoLRE
switch.
3. Connect a PhyLink adapter to the Network jack on each IP phone and connect the other end of the
PhyLink adapter into the RJ11 cable that is connected to wall jack.
Note: Do not locally power an IP phone while using the PhyLink adapter.
4. Connect the RJ11 plugs to the RJ11 jacks on the PoLRE Switch.
5. Connect the CAT5 cable from an Uplink port to the IP PBX or network switch.
6. Connect the DC Power Adapter Plug to the DC Jack located at the back of the PoLRE LP Switch.
7. Power up the PoLRE Switch.
Note the following:
All of the above instructions provide basic installation information, necessary for the proper and safe
functioning of this equipment. Persons installing or maintaining this product must read all of the safety
instructions and the parts of system grounding which are applicable to the system being maintained.
Only trained, qualified service personnel shall install or maintain this product.
WARNING: FAILURE TO FOLLOW ALL INSTRUCTIONS MAY RESULT IN IMPROPER
EQUIPMENT OPERATION AND/OR RISK OF ELECTRICAL SHOCK.
WARNING: ANY CONNECTION TO AN OUTSIDE PLANT LEAD, AN OFF-PREMISE
APPLICATION, OR ANY OTHER EXPOSED PLANT APPLICATION MAY RESULT IN A
FIRE OR SHOCK HAZARD, AND/OR DEFECTIVE OPERATION, AND/OR EQUIPMENT
DAMAGE.
•
Keep these instructions with the equipment.
•
Do not attempt to install or service this equipment unless you are skilled in the installation and
maintenance of electronic telecommunications equipment and have successfully completed specific
training for this equipment.
Technical Support
The Phybridge Technical Support Group is available to assist you with product installation,
configuration, monitoring and troubleshooting procedures. Should you experience trouble with this
equipment or for repair or warranty information, please contact Phybridge Inc. at +1 905.901.3633 or
support@phybridge.com
.
