©2018 Physio-Control, Inc.
21
Regulatory Compliance Information
Separation Distances
Regulatory Compliance Information
Federal Communications (FCC) Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Hereby, Physio-Control declares that the radio equipment type TrueCPR Coaching Device is in compliance with
Directive 2014/53/EU. The full test of the EU declaration of conformity is available at the following internet address:
www.physio-control.com/EUDoC
Table 4
Recommended separation distances between portable and mobile RF communications equipment and the
TrueCPR device, model 80596-000001.
The TrueCPR device is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. The customer or user can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the TrueCPR device as
recommended below, according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter (W)
Separation distance according to frequency of transmitter (m)
150 KHz to 80 MHz
d
= 1.2
80 MHz to 800 MHz
d
= 1.2
800 MHz to 2.5 GHz
d
= 2.3
0.01
0.12
0.12
0.23
0.1
0.38
0.38
0.73
1
1.2
1.2
2.3
10
3.8
3.8
7.3
100
12
12
23
For transmitters rated at a maximum output power not listed above, the recommended separation distance
d
in
meters (m) can be determined using the equation applicable to the frequency of the transmitter, where
P
is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
Note 1:
At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2:
These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
P
P
P
