Stimulation Current Therapy
28
IONOSON-IF-Expert
4.6
Therapy using medium-frequency current modes
4.6.1
Therapy using classic interference current IF::
Treatment Procedure
(1)
Attach the electrodes to the stimulation points. Make sure that the four elec-
trodes of the two circuits are fixed crosswise.
(2)
Select the current mode
IF
from the
display <3>
.
(3)
If necessary, select the vector function
DYNAM.
.
(4)
Depending on the indication, select a frequency band or a fixed frequency.
(5)
If necessary, alter the basic frequency.
(6)
Set the therapy time.
(7)
If necessary, plug in the manual release key as therapy pause button.
(8)
Slowly turn up the intensity in circuit I with the
intensity control circuit I <6>
.
The therapy time elapses.
Warning
Take care that the electrodes are by no means touched after the cur-
rent is turned up!
(9)
Slowly turn up the intensity in circuit II with the
intensity control circuit II /
dose <8>
. Make sure that the sensation of the current is the same for all elec-
trodes.
(10)
After treatment, an acoustic signal will be issued.
Turn the intensities of both circuits down to 0.
(11)
Remove the electrodes.
Note
The current mode IF requires both circuits I and II simultaneously. You
can not carry out an additional therapy with circuit II.
