Controls and Indicators
IONOSON-IF-Expert
13
2.3.2
Dual channel operation
For all current modes except
IF::
you can select additional current modes (dual
channel operation) in circuit II .
2.3.2.1
For all current modes except IF and G
The current mode set in circuit I (except for
G
) can also be selected with the same
parameters in circuit II. AMF and MT can always be selected.
2.3.2.2
For the MT and KOTS current modes
The current mode set in circuit I can also be selected in circuit II, whereby individual
parameters can be set independently for both circuits. With circuits I and II, stimula-
tion can be either simultaneous or alternating. Carry out the following operational
steps:
(1)
Select the desired current mode in both circuits.
(2)
With the
data selector <5>
, first click on the
selection field and turn
the selector to the left until the desired icon appears (e.g. for simultaneous
stimulation). The parameter R will acquire the appropriate value.
Simultaneous stimulation
Circuits I and II stimulate simultaneously with the same pa-
rameters. The polarity and ramp of the surge current can be
freely selected in each circuit.
To adjust the threshold time and threshold interval, carry out the operational steps
1-2 described above, and then proceed as follows:
(3)
With the
data selector <5>
, first click on the
selection field in circuit
I.
(4)
In the new window, click on the
selection field
, turn the selector to the
right and select the duration of the surge interval.
(5)
In the same window, click on the
selection field
, turn the selector to
the right and select the duration of the surge time.
(6)
Leave the window via the
button.
All current modes
can be applied in
both circuits
