40
NEOX™ Tilt-in-Space
ENGLISH
14. Anti-tip tubes
14.1 Inserting anti-tippers in Receiver
Press the rear anti-tipper release pin
A
on the anti-tipper tube so that
both release pins are drawn inside.
Insert into the anti-tipper receiver.
Slide the anti-tipper until release
pin is positioned through the lower
receiver mounting hole. Repeat the
process with the second anti-tip
tube.
14.2 Adjusting anti-tippers
Once the anti-tipper is installed, you must adjust its height to the proper
setting. To do so, press anti-tipper release pin
B
and raise or lower the moving
part of the anti-tipper.
Figure 58: Remove and adjust the anti-tip
Make sure the anti-tippers are fully engaged and release buttons fully
protruding out of adjustment holes. Anti-tippers must always be use.
When outdoors on wet, soft ground or on gravel surfaces, anti tippers
may not provide the same level of protection against tipover.
Physipro recommends anti-tippers for all wheelchairs. The anti-tippers are
not to be used as tipping levers.
Always verify if the anti-tippers are at proper height after making any
adjustment or modification to the wheelchair in order to ensure the safety
of the user.
