Owner’s Manual
ENGLISH
29
Note -
Depending on the selected size of the propulsion wheels, the seat-to-floor height
may be limited to 13", 14" or 15".
6-Wheel Configuration Table
Propulsion Wheel
Diameter
Seat-to-Floor
Height
Required Position
P1
P2
20" (510 mm)
13" to 17"
(330 to 430 mm)
X
22" (560 mm)
14" to 18"
(360 to 460 mm)
X
24" (610 mm)
15" to 19"
(380 to 480 mm)
X
Note -
The desired seat-to-floor height of the 6-Wheel Neox Dynamic wheelchair will
be determined by the size of the propulsion wheels only. The caster wheels are
supplied and pre-assembled to dynamic forks with a diameter of 5" (127 mm) or 6"
(152 mm).
Modifying the position of the axle mounting block
1. Remove propulsion wheels by referring to
section
Removing propulsion wheels -
Threaded axle
or
Removing propulsion
wheels - Quick-Release axle
, depending on
the type of axle installed
2. Unfasten nuts
A
with a 13 mm wrench
and remove bolts
B
.
3. Determine if mounting block
C
should be
placed upward or downward on the side
frame rail to obtain the desired seat-to-
floor height. Move the mounting block
C
forward or backward to the desired
location.
4. Reinsert bolts
B
and tighten nuts
A
.
5. Reinstall propulsion wheel at the desired
position (see
Configuration Tables
).
R
e
vision 0
July
202
2
