NEOX
TM
Dynamic wheelchair
ENGLISH
30
WARNING
•
After modifying the position of the propulsion wheels on the axle
mounting blocks, you may need to readjust the position of caster
wheels on the fork or change caster wheel diameter.
•
Always position the propulsion wheels as far back as possible, this will
guarantee maximum stability and ensure there is enough space in
front of the propulsion wheels to properly install wheel locks.
Modifying the position of the caster wheels
1. With two 13 mm wrenches, unfasten
bolt
A
and remove spacers if necessary.
2. Refer to the
Configuration Table
of your
wheelchair to determine the correct
caster wheel position in order to obtain
the desired seat-to-floor height.
3. Line up the caster wheel with the
appropriate adjustment hole.
4. Reinstall spacers, if needed, and
reinsert and tighten bolts
A
.
Note
-
Make sure the wheel rotates easily
once the bolt has been installed.
