NEOX
TM
Dynamic wheelchair
ENGLISH
50
Installing the stroller bar (option)
The Neox
TM
Tilt-in-Space wheelchair must be equipped with specifically designed
back posts for the installation of the angle adjustable stroller bar. If your wheelchair is
currently equipped with standard back posts, you must replace them before
beginning the installation of the stroller bar. Steps 1 to 5 explain how to remove the
standard back posts and install the stroller bar back posts. If your wheelchair is
already equipped with the appropriate back posts, you can procced directly to steps
6 to 9.
1. With a 4mm Allen key, unfasten
screws
B
and remove tension bar
A
.
2. With a Philips screwdriver, remove
activation lever(s) (see section
Installing an activation lever
).
3. With a 10mm wrench, unfasten
screws
C
. Remove back posts
D
by
pulling upwards.
4. Install the stroller bar back posts
E
and fasten screws
C
.
5. Insert adapters
F
into back posts
E
and fasten screws
G
.
6. Reinstall tension bar
A
onto the
back posts
E
.
7. With a 3mm Allen key, unfasten
screws
H
completely and adjust the
width of the stroller bar. Once the
desired width is obtained, reinsert,
and fasten screws
H
.
8. Insert stroller bar into adapters
F
and fasten screws
I
with a 3mm
Allen key.
9. Reinstall activation lever(s).
