Owner’s Manual
ENGLISH
53
Limiting the tilt angle
1.
With a 7/64'' Allen key, loosen screws
A
, located on
lock
ing collars
B
.
2.
Position the
lock
ing collars
B
at the
desired location on both cylinder
rods
C
to limit tilt.
3.
Tighten screws
A
firmly.
Replacing the self-blocking cylinder
The following steps explain how to replace the self-blocking cylinder. It is important to
follow these steps in the order indicated.
1. Make sure the seat is parallel to the
ground (see section
Adjusting the tilt
angle
) to improve safety during
cylinder replacement.
2. Unfasten and remove the cylinder
cable.
3. With a 4mm wrench, unfasten and
remove screws
A
.
4. With a 4mm Allen key and a 10mm
wrench, unfasten shoulder screw
B
.
5. With a 4mm Allen key, unfasten
screws
C.
6. With a 19mm wrench, unfasten the
cylinder end
D
from the old cylinder
and install on the replacement
cylinder.
7. With a 4mm Allen key, fasten screws
C.
8.
With a 4mm Allen key and a 10mm
wrench, fasten shoulder screw
B
.
9.
With a 4mm wrench, fasten screws
A
.
Note -
Make sure that all hardware is
properly reinstalled and that
each screw is firmly tightened.
10.
Fasten the cylinder cable to the new
self-blocking cylinder.
R
e
vision 0
July
202
2
