NEOX
TM
Dynamic wheelchair
ENGLISH
34
Follow these steps to adjust the horizontal position of the propulsion wheel:
1. Remove the propulsion wheel. Depending
on the type of axle installed, refer to
section
Removing Propulsion Wheels –
Threaded Axle
or
Removing Propulsion
Wheels – Quick-Release Axle.
2. Unfasten nut
A
with a 13 mm wrench and
remove bolts
B
.
3. Move mounting block forward or
backward on the side frame rail until the
desired position is obtained.
4. Reinsert bolts
B
and tighten nuts
A
firmly.
5. Reinstall propulsion wheel.
WARNING
Always position the propulsion wheels as far back as possible, this will
guarantee maximum stability and ensure there is enough space in front of
the propulsion wheels to properly install wheel locks.
Propulsion wheel lateral positioning
This modification is used to move the propulsion wheels closer or further from the frame.
Follow these steps to adjust the lateral position of the propulsion wheel:
1. Remove the propulsion wheel. Depending on the
type of axle installed, refer to section
Removing
Propulsion Wheels – Threaded Axle
or
Removing
Propulsion Wheels – Quick-Release Axle.
2. With a 1
⅛
" wrench, loosen nut
A
.
3. Unscrew or screw the axle bushing
B
, closer or
further from the frame, depending on the desired
lateral position of the propulsion wheel.
4. Tighten nut
A
firmly.
5. Reinstall the propulsion wheel.
WARNING
After adjustments are made, make sure all assembly hardware is firmly
tightened, otherwise injury or damage may occur.
