39
Revision 5
December 2015
Owners manual
ENGLISH
B
A
Always verify if the anti-tippers are at a proper height after making any
adjustments or modifications to the wheelchair in order to ensure the
safety of the user.
For maximum safety, the distance between the ground and the anti-
tipper must not exceed 2".
Physipro recommends anti-tippers for all wheelchairs
Make sure the anti-tippers are fully engaged and release buttons fully
protruding out of adjustment holes. Anti-tippers must always be used.
When outdoors on wet, soft ground or on gravel surfaces, anti tippers
may not provide the same level of protection against tipover. Ensure both
anti-tippers are adjusted to the same mounting hole.
14. Anti-Tip Tubes
14.1 Inserting Anti-tippers In Receiver
1. Press the rear anti-tipper release
pin
A
on the anti-tipper tube so
that both release pins are drawn
inside. Insert into the anti-tipper
receiver.
2. Slide the anti-tipper until release
pin is positioned through the
lower receiver mounting hole.
3. Repeat the process with the
second anti-tip tube.
14.2 Adjustment
Once the anti-tipper is installed, you must adjust its height to the proper
setting. To do so, press anti-tipper release pin
B
and raise or lower the moving
part of the anti-tipper.
14.3 Remove the anti-tippers
To remove the anti-tippers, simply press on the release pin
B
and pull the anti-
tipper.
Figure 42 : Anti-Tip Tubes
The anti-tippers are not to be used as tipping levers.
