Manual I1AM02
MA 1296-A010 EN
16
5 Installation
Phytron always delivers the
phyMOTION
™ completely assembled in order to make sure
you can start with the installation and the wiring right away.
Further manual
Detailed information on this subject is in a supporting manual:
“
phyMOTION
TM
Modular Multi-
axis Controller for Stepper Motors”
5.1 Mechanical Installation
In case you receive an individually packed I1AM02 as an expansion module or after repair
or service unpack the module in ESD protected area only.
CAUTION
– Possible damage by ESD!
T
he modules of the
phyMOTION
TM
consist of sensitive electronic
components that can be destroyed by electrostatic discharge voltages.
- Always store and transport single modules in ESD protective
packaging.
- Always handle the components in compliance with the ESD protection
measures.
- No liability is accepted for any consequences resulting from improper
handling or non-ESD-friendly packaging.
i
CAUTION
– Possible damage!
The I1AM02 module is designed for a maximum supply voltage of 70V
DC
. If it
is supplied with >70 V
DC
the card might be damaged.
- Make sure that a power module (POWM01, POWM02) is supplied on
the left with less than 48 V
DC
to avoid damage.
Before integrating or switching modules always make sure that the
phyMOTION
™ is shut
down and the power supplies are disconnected.
Summary of Contents for phyMOTIONT I1AM02.1
Page 9: ...phytron 9 MA 1296 A010 EN 4 Technical Data 4 1 Declaration of Incorporation...
Page 10: ...Manual I1AM02 MA 1296 A010 EN 10...
Page 30: ...Manual I1AM02 MA 1296 A010 EN 30 Fig 6 6 wire LVDT RVDT wiring...
Page 31: ...phytron 31 MA 1296 A010 EN Synchronisation Fig 7 Synchronisation wiring...
