6 Starting and Operating
M-687.UN XY Stage
MP100E
Version: 1.3.0
29
Requirements
You have read and understood the general notes on starting and operating (p. 25).
You have read and understood the user manual for the controller (p. 3).
The M-687.UN is properly installed (p. 15).
The controller (p. 11) and the required software have been installed. All connections on
the controller have been made (refer to the controller manual).
Starting and operating the M-687.UN with the C-867 controller
Operate one axis of the M-687.UN (refer to controller manual), and repeat the
sequence for the second axis.
Starting and operating comprises the following steps:
−
Selecting the positioner type
−
Referencing the axis
−
Commanding initial motion in closed-loop operation for testing and for running the
mechanics in
The controller manual describes starting and operating using the PIMikroMove
program.
