6 Starting and Operating
M-687.UN XY Stage
MP100E
Version: 1.3.0
25
In this Chapter
General Notes on Starting and Operating ................................................................................... 25
6.1
General Notes on Starting and Operating
CAUTION
Risk of electric shock if the protective earth conductor is not connected!
If a protective earth conductor is not or not properly connected, dangerous touch voltages can
occur on the M-687.UN in the case of malfunction or failure of the system. If there are touch
voltages, touching the M-687.UN can result in minor injuries from electric shock.
Connect the M-687.UN to a protective earth conductor (p. 16) before starting.
Do
not
remove the protective earth conductor during operation.
If the protective earth conductor has to be removed temporarily (e.g., in the case of
modifications), reconnect the M-687.UN to the protective earth conductor before
restarting.
NOTICE
Destruction of the piezo motor due to electric flashovers!
Using the M-687.UN in environments that increase the electrical conductivity could lead to the
destruction of the piezo motor by electric flashovers. Electric flashovers can be caused by
moisture, high humidity, liquids, and conductive materials (e.g., metal dust). In addition,
electric flashovers are also possible as a result of increased conductivity in certain air pressure
ranges.
Avoid operating the M-687.UN in environments that can increase the electrical
conductivity.
Operate the M-687.UN only under permissible ambient conditions and classifications
(p. 39).
NOTICE
Damage if the wrong controller is connected!
Connecting an XY stage to an unsuitable controller can damage the XY stage or controller.
Connect an XY stage with PILine® ultrasonic piezo motors only to a PILine® controller
(p. 11).
6
Starting and Operating
