6 Startup and Operation
28
Version: 1.3.0
MP144E
N472 Linear Actuator
Pay attention to further information on the operating conditions in the "Technical Data" section
(p. 37).
The N-472 is put into operation with a suitable controller (p. 12) from PI.
6.2
Operating Parameters
If you use the software that is in the scope of delivery of the controller (p. 12), the operating
parameters of the can be loaded from the positioner database. The entries in the positioner
database are updated regularly.
Install the PI Update Finder from the product CD of the controller onto your PC and
update the positioner database on your PC.
For more information on the positioner database, see the user manual for the controller (p. 12).
6.3
Operating the N472
INFORMATION
Two modes of operation are available for the N-472:
Servo mode switched off:
Motion is commanded with the
OMA
command. The target position is approached in stepping
mode. When the target position is reached, stepping mode is switched off and the N-472 stops.
Servo mode switched on:
Motion is commanded with the
MOV
command. The target position is approached in stepping
mode. When the the target position is reached, the analog control mode switches on for fine
positioning. Control remains active.
Requirements
You have read and understood the general notes on startup and operation (p. 25).
You have read and understood the user manual of the controller.
You have read and understood the user manual of the PC software.
You have properly mounted the N-472 (p. 17).
The controller and the required PC software have been installed. All connections with
the controller have been established (see user manual of the controller).
Operating the N472
Follow the instructions in the manual for the electronics (p. 12) used for startup and
operation of the N-472.
