5 Installation
22
Version: 3.2.0
PZ82E
P-5x7/P-5x8 Positioners
NOTICE
Center of load at unsuitable position!
If the center of load is located too far away from the center of the motion platform (e.g., tall
load and unwanted lever effect), the P-5x7/P-5x8 can be damaged, especially in dynamic
operation, by high strain on the flexure guides, high torques, and oscillations.
If the center of the load to be fixed is too high or to the side of the motion platform, adjust
the controller settings before starting and operating or or contact our customer service
department (p. 35).
NOTICE
Excessively long screws!
The P-5x7/P-5x8 could be damaged by screws inserted too deeply.
Pay attention to the depth of the mounting holes in the motion platform (p. 42).
Use screws of the correct length for the respective mounting holes only.
INFORMATION
The positive direction of motion is specified in the dimensional drawing (p. 42) by arrows.
Center of load at the optimal position:
Figure 5: Example of an optimally placed load
Center of load at an unsuitable position:
Figure 6: Tall load and center of load too far above the platform
