PZ240EK 6.1.0 10/2019. 2.0
M O T I O N | P O S I T I O N I N G
Uncontrolled oscillation can damage your appli-
cation or the positioner.
X
If oscillation occurs, switch off the servo
mode or stop the positioner immediately.
X
Check the settings of the servo control
parameters (see manual).
Handling Vacuum-Compatible Products
If the positioner is vacuum-compatible, attenti-
on must be paid to cleanliness.
X
Touch the positioner only with powder-free
gloves.
X
If necessary, wipe the positioner clean.
NOTICE!
Damage due to improper handling.
X
Hold the positioner only on the outsi-
de of the base body.
If the positioner was delivered with a transport
safeguard:
1. Lay the positioner onto a surface with the
supporting frame facing downwards.
2. Unscrew the four plastic screws.
3. Remove the plastic screws and the suppor-
ting frame.
1. Mount the positioner using the mounting
holes provided.
2. Affix the load to the mounting holes provi-
ded.
3. Check that the positioner and the load are
fixed firmly.
Correct Mounting
Mounting on an Uneven Surface
Incorrect Alignment of the Load
Incorrect Fitting of the Screws
Removing the Transport
Safeguard
Mounting the Positioner
and Load
