6 Startup and Operation
Q-522 Miniature Stage
MP134E
Version: 1.0.1
37
INFORMATION
The PIShift drive develops noises in step mode. The noise development depends on
the current step frequency.
6.2.1 Starting Up the Q-522.x0z with the E-870 Drive Electronics
INFORMATION
The values for the parameters of the E-870 drive electronics are listed in a table in
this section (p. 38).
For optimum drive performance, the values of the following parameters should be
identical:
PIShift Steps per Second
(ID 0x1F000600)
PIShift Frequency
(ID 0x1F000400)
Prerequisites
You have read and understood the general notes on start-up and operation
(p. 33).
You have read and understood the documentation of the E-870 drive
electronics (E870T0001 Technical Note or E870T0002 Technical Note).
You have properly installed the stage (p. 19).
The E-870 drive electronics has been properly installed, and all connections
on the E-870 have been set up (see E870T0001 Technical Note or
E870T0002 Technical Note).
Starting up the Q-522.x0z with the E-870 drive electronics
1. Make sure that the parameters of the E-870 drive electronics have been set
correctly; for values, see table below (p. 38).
2. Provide the control signal required for operating the system. Details can be
found in the E870T0001 or E870T0002 Technical Note.
3. If necessary: Adapt the
PIShift Steps per Second
parameter
(ID 0x1F000600) and the
PIShift Frequency
parameter (ID 0x1F000400) to
your application (see also "Operating Time" (p. 50)).
