5 Installation
Q-632 Miniature Rotation Stage
MP129E
Version: 1.1.2
19
5.3
Fixing the Load to the Q-632
NOTICE
Impermissibly high forces and torques!
Impermissibly high forces and torques that are applied to the motion platform can damage the
Q-632.
For fixing type and mass of the load, pay attention to the maximum permissible forces
according to the specifications (p. 37).
Avoid tilting torques at the motion platform.
NOTICE
Excessively long screws!
The Q-632 can be damaged by excessively long screws.
Note the depth of the mounting holes in the motion platform (p. 40).
Use screws of the correct length for the respective mounting holes only.
Figure 6: Black arrows indicate locating holes for alignment of the load, whereas white arrows
indicate threaded holes for fixing the load
Requirements
You have read and understood the general notes on installation (p. 15).
You have fixed the Q-632 onto an underlying surface (p. 16) properly.
The Q-632 is
not
connected to the electronics.
You have prepared the load so that it can be fixed to the motion platform (for the
required position and depth of the holes for accommodating the screws and locating
pins, see "Dimensions" (p. 40)):
−
The gap between the center of gravity of the load and the center of the motion
platform is as small as possible in all directions.
−
Four points are provided for fixing the load to the motion platform.
