5 Installation
V-273 VC Linear Actuator
MP124E
Version: 1.0.0
15
In this Chapter
General Notes on Installation ...................................................................................... 15
Optional: Changing the Contact Piece of the Force Sensor on the V-273.431 Model:16
Installing the V-273 in a Mechanical Mounting ............................................................ 17
Connecting the Motor Cable to the V-273 ................................................................... 20
5.1 General Notes on Installation
NOTICE
Heating up of the V-273 during operation!
The heat produced during operation of the V-273 can affect your application.
Install the V-273 so that the application is not affected by the dissipated heat.
Ensure sufficient ventilation at the place of installation.
Make sure that the complete bottom side of the V-273 is in contact with the
surface on which the V-273 is mounted.
NOTICE
Lubricants, dirt, condensation!
Dirt, oil, lubricants and condensation will render the motor/drive inoperable.
Keep the V-273 free from lubricants.
Keep the V-273 free from dirt and condensation.
INFORMATION
If unsuitable cables are used, interference can occur in the signal transmission
between the linear actuator and the controller.
Only use original PI parts to connect the linear actuator to the controller. The
maximum cable length is
1 m
.
If you need longer cables, contact our customer service department (p. 31).
5
Installation
