6 Start-Up and Operation
V-273 VC Linear Actuator
MP124E
Version: 1.0.0
21
In this Chapter
General Notes on Start-Up and Operation .................................................................. 21
Starting Up the V-273 with the C-413 Controller ......................................................... 24
6.1 General Notes on Start-Up and Operation
The start-up of the V-273 is done with the PIMag® C-413 motion controller from PI.
NOTICE
Heating up of the V-273 during operation!
The heat produced during operation of the V-273 can affect your application.
Ensure sufficient ventilation at the place of installation.
Ensure that the average continuous current and the peak current do
not
exceed
the permissible values (p. 33).
NOTICE
Operating voltage too high or incorrectly connected!
Operating voltages that are too high or incorrectly connected can cause damage to
the V-273.
Only operate the V-273 with controllers/drivers and original accessories from PI.
Do
not
exceed the operating voltage range (p. 35) for which the V-273 is
specified.
Only operate the V-273 when the operating voltage is properly connected; see
"Pin Assignment" (p. 40).
6
Start-Up and Operation
