-6-
PKI-0041-5-E
● When using a commercially supplied lamp bracket, before removing the bolt that is already installed
on the car body, make sure that it is safe to do so.
● The lamp should be mounted in an area suffi cient to support its size and weight.
Failure to do so may result in excessive vibration leading to shorter bulb life and or physical damage
to the lamp or your vehicle.
● Do not attempt to install the lamp directly to any plastic part of the car body.
● When installing, make sure the lamp body, lens and rim are not touching the bumper and other plastic
parts. Such plastic parts might deform.
● The lamp installation surface should be fl at.
● The lamp should be tightened to the degree that the lamp body cannot be moved by hand.
● The lamps are designed to be mounted upright. It is very important that you make sure that the PIAA
etched in the lens reads right side up.
For lamp installation, a hole with a diameter of
10mm is required. Make necessary preparation
such as installation of lamp bracket.
Hex nut
( L/Item ④ )
【2】Lamp installation
Rubber cushion
( Item ⑤ )
Tightening torque：18ft・Ibs (24N・m)
Side cap
( Item ⑨ )
Side cap
( Item ⑨ )
