Code 4
Code no. 4 denotes a system where the decoder
is blank and the control unit is programmed.
The key is recognised by the control unit.
- Start-up disabled
- Indicator light
N.B.
REPEAT THE KEY PROGRAMMING PROCEDURE USING THE ORIGINAL MASTER KEY.
Diagnosis guide
Immobiliser LED does not come on
1
- Check whether the injection indicator turns on
for 5 sec. after switching to "
ON
"
YES go to 2 NO go to 11
2
- Check 7.5A fuse No.10 located on the front
glove-box.
YES go to 4 NO go to 3
3
- Check for any short circuits on the instrument
unit power supply line, check that the instrument
unit has not short-circuited
YES go to 5
4
- Check whether the LED comes on when pin No.
2 of the decoder connector is connected to ground
(yellow/grey cable).
YES go to 6 NO go to 7
5
- Restore
YES go to 2
6
- Replace the decoder and reprogram.
7
- Check for continuity on the yellow/grey cable,
measuring between the decoder connector and
the 8 pin connector of the instrument panel
YES go to 8 NO go to 10
Beverly 500 i.e.
Injection
INJEC - 223
Summary of Contents for Beverly 500 i.e.
